Single Clear Laser Printed Waterslide as pictured in listing Approximately 3.5-4” depending on design. These are perfect size for a tumbler. The actual waterside will come without the watermark. Please see the instructions below: 1. Cut out the image 2. Place it in warm water for approx. 30 Seconds 3. Wet down area on tumbler that you’d like to place the waterslide 4. Slide the waterslide onto the tumbler. 5. Take a damp paper towel and smooth out and wrinkles in the slide. 6. Let completely dry before adding epoxy. **Sorry, I do not sell the file for this. I only sell the actual waterslide**