2 Laser cut 3/16 plywood toy car display rack. This is the original artifact design co 1:64 diagonal design (unlike the copies made in China). We use sustainably sourced domestic wood and make at our home here in the USA! Entire rack measures only 17” by 17”. Rack will hold 66 1:64 die-cast cars. Slots are slightly oversized at 3.5”x1.5” to hold the longer and taller cars. Wheel stops are cut in the shelf to prevent rolling. Shelf shows off more of your collectible car by allowing 3 sides to be seen. You will receive 34 unfinished pieces that will easily fit together with wood glue. Although pictures are of the rack not glued and it stays together nicely, glue should be used to reinforce the rack. You will also receive general instructions. The pieces are laser cut so they will smell like burnt wood but the smell should disappear within a few days. They will also have a laser smoke residue on them but that can be easily cleaned off or covered up with stain or paint. We typically leave ours alone because we like the rustic look. You can purchase the shelves with or without wood glue. Made in our home in North Carolina, USA. There are wall mounting points that are 16 inches on center. Please follow the instructions for assembly that are included with your order. This item was created by us at artifact design co. We do not sell our files nor do we allow duplicates as it’s a copyright of artistic creativity. If item is being mailed to Hawaii or Alaska, please message us first. There is an additional charge for shipping. Thank you for visiting artifact design co! We do not accept returns unless item is defective.
