Illuminated stainless steel house number plaques in Gill Sans font with back lit LEDs. These are bespoke, high quality products designed and assembled here in the UK. *OUR ILLUMINATED HOUSE NUMBERS REQUIRE INSTALLATION INTO THE MAINS ELECTRICITY SUPPLY AND WE WOULD RECOMMEND THAT THEY ARE INSTALLED BY A QUALIFIED ELECTRICIAN.* *PLEASE NOTE* : Our LED Illuminated products can only be supplied to the UK and Ireland due to limitations on adapting these products for use with overseas electrical supplies. Your house number plaque will be laser cut from 304 grade 3mm thick brushed stainless steel or acrylic, with a 5mm frosted acrylic backing plate. and high quality long lasting IP rated LED units. The material and colour options are as follows: Black Acrylic (matt) Charcoal Grey Acrylic (matt) Stainless Steel (304 grade, brushed, silver in colour) Black powder coating matt (over 304 grade stainless steel) Anthracite grey powder coating matt (over 304 grade stainless steel) SIZES: one or two digits - 150mm high * 200mm wide three digits - 150mm high * 250mm wide The plaques come with hidden fixings suitable for masonry which allow them to stand-off from the wall and for the light to flood the area at the back of the plaque. LEDs provide the combined benefit of low energy consumption and long life. The LEDs we use on these numbers are suitable for outside use in all weather conditions. Our LEDs come in Cool White (6000 Kelvin), Warm White (3000 Kelvin) or Blue. Please use the drop down menu to order your LED colour or contact us if you require anything different. With your order we include a "hard wire" driver to run the LEDs on your house numbers, which allows your electrician to hard wire your house number into your house wiring - this is an ideal solution if your house numbers are being added to a new build, an extension or a gate post or pillar. If you would prefer a simple "plug in" driver which will allow your electrician to run your illuminated house number cable back into your house and plug into the nearest standard three pin plug inside, then please contact us after you place your order. Your electrician will also be able to add a timer or dusk till dawn sensor to the circuit, however these are NOT supplied by us. Can illuminated house numbers or name plates be used with a dimmer? No, there are not enough LED modules on our illuminated numbers and small backlit plaques to produce an “efficiency curve” necessary to dim the modules successfully. This is because at 0.25 watts each they do not make up enough total wattage for the minimum load requirement of a dimmable driver which is 6 -7 watts.