Sacred Geometry Merkaba Symbol 3-D printed black mystical symbols to be used as-is or painted to match your own personal taste! This particular symbol is known as the Merkabah or Merkaba. Each piece is 5mm thick, you choose the length! These are very lightweight and can be hung with a small nail, thumbtack, command hook, or any other method of your choosing. They can also be used to decorate your altar! (Do keep them away from lit candles to prevent melting and layer separation) Other sizes are available as custom orders upon request. These are raw prints, as in they are right off the printer, no primer or paint has been applied. As shown in the photos, layer lines are visible on raw prints, especially on the shiny side. The 3rd and 4th photos show examples of the layer lines up close. One side of each print is shiny, and the other side has a matte texture finish. These can be painted with any paints, resin, enamel paints, paint pens, etc. I have found the best process to include spraying them with a primer and giving them light sanding before painting. Be sure to complete your painted pieces with a clear protective coat to make them more durable and prevent your hard work from chipping off. Each order comes with the care card shown in the photos. ~~IMPORTANT~~ Be sure to double-check the shipping address before placing an order. Once orders have been shipped out, I cannot do anything to change the address. These were designed by me with special 3-d designing software and printed out on 3-D printers with PLA (a thermoplastic polyester), which is produced from renewable resources (plants) and is biodegradable. All PLA prints will need to be sealed before contact with water or resin as it is porous. Keep away from heat and long periods of direct sunlight to prevent melting and layer separation. 3D printing, also known as additive manufacturing, is a method of creating a three-dimensional object layer-by-layer using a computer-created design. 3D printing is an additive process whereby layers of material are built up to create a 3D part. Layer lines will be visible on raw prints but can be filled in with primer before painting. If you have questions about the material or process please send me a message!