I love tutorials so I thought I’d have a go at doing one. Now I’ve included photos of every step which is probably overkill but you’ll certainly get the gist of it. Now this is how ‘I’ make mug rugs. I’m sure there are lots of different ways to do it & there is no right or wrong way. I think the trick is to look around & choose the method that you like. The first 2 rugs I made, I added separate binding, which I found fiddly. The 3rd rug I decided to simply cut the backing bigger & fold it over. On that one I stitched around the edge of the rug before folding over the binding but this time I thought if I put the pellon on glue side down I could iron the backing to it & save the sewing around step. It worked well. :-) MUG RUG I looked for a standard size but they vary. I settled on 9” x 6” finished. Here’s one I prepared earlier: MATERIALS a range of fabrics you love Iron-on pellon, medium-weight not light-weight threads to match First I choose a feature fabric. Then I choose fabrics to match. Cut a strip from each fabric. They should be between 1 1/2’ & 2” wide. They vary in length, the longest for the centre strip is 9”, then 8”, 6 1/2” & 4 1/2”. If you have more or less strips these measurements will vary. You can cut your strips as you go, so you can check how long they need to be. Cut a 6 1/2” x 9 1/2” piece of iron-on pellon. The standard thickness, not thin. Draw a line, 3 1/4” from the right side on the side of the pellon that DOESN’T have the glue on it. Lay your longest strip across the ‘square,’ right side up. Lay your 2nd strip right side down on the first & stitch. Pins are optional. Stop stitching once you are approx. 1/4” past the line you drew. You will trim the excess later. Flip the sewn piece over & finger press in place. Keep adding strips until you’ve covered that side. Add strips to the other side. When covered, trim the fabrics & pellon back on 3 sides. It should now measure 6” x 9 1/4”. Turn your work over & fold the pellon back. Trim the excess fabrics back, making sure the edge is perpendicular to the other side. Cut a 4” x 6 1/4” piece of your feature fabric & sew it to the edge of the stripes. Flip the fabric back & trim any excess so the rug measures 6” x 9” Cut an 11 1/2” x 8 1/2” piece of backing fabric. Centre the rug on the backing & pin in place. The glue side of the pellon is now against the backing. Turn the rug over & iron a section where there is no pin, to hold it in place. When it is lightly attached remove the pins & press well. Turn back over & trim the backing back to 1” all around the rug. BINDING Cut a 5/8” square our of each corner to cut back on the bulk. Turn the binding in half, then half again over the front of the rug. Pin in place. Turn the corner over 45 degrees. The pin is so I could take the photo as I didn’t have a third hand. :-) Fold the hem in half. Finally fold it over again & pin. You might have to fiddle a little to get a neat corner but it doesn’t take long. Hand stitch the binding in place & enjoy your mug rug. NOTE: I can’t guarantee you won’t catch the Mug Rug Bug!!! :-)