I love printing cute spinners for classroom games. I do not love the chaos that ensues when the kids use pencils and paper clips for the spinner. Pencils and clips go flying, holes get poked in the spinner, and usually there is an argument about accuracy. I tried using a brad, but the paper clip wouldn't spin freely creating even more problems. So I did a little adjusting and now I think I have found something that works! Make a starter hole in the laminated spinner for the brad. Fold the back of the brad in the middle of the brad, not at the top, so that the brad is sticking up from the paper about half an inch. Tape the back of the brad to the back of the spinner to secure it. This is what it should look like once it is secured. Slip the paper clip over the brad. Start spinnin'!