For a small robot project I'm working on I needed a way to measure the robot's progress across the floor. There are various possibilities, such as: use stepper motors (expensive and am recycling some old continuous run servos), add an encoder to the wheels (would need to go buy some parts for that), or use the optical sensor for a mouse. I had a really old PS/2 optical mouse lying around which contains an MCS-12085 optical sensor that has a rather simple serial interface suitable for connection to a microcontroller. Inside there are two separate areas of components. On the right in the picture above is the PS/2 interface chips and four nice extras that I desoldered for later use (three microswitches and a quadrature encoder). On the left is the red LED that illuminates the surface and the 8 pin square MCS-12085 that has the camera. The only description of the chip was for a related optical sensor, the MCS-12086. The difference between the two appears to be that the MCS-12085 requires an external oscillator. A quick comparison of one of the designs in the datasheet and the PCB reveals the simple circuit that runs the chip: Here's a marked up picture of the mouse internals: The reverse side shows that there's a nice clean separation between the optical sensor side and the PS/2 interface. So, after taking a hacksaw to the PCB and case, exposing some copper tracks with sand-paper and drilling four holes for +5V, GND, SDIO and SCLK it was possible to attach a small piece of the PS/2 cable and some connecting pins to have a stand-alone optical sensor unit for my robot. Then it's just a question of software. For this project I'm using an Arduino Uno which can easily supply the 5V that the sensor needs and two digital pins can be used to generate the clock and I/O signals to read the movement of the sensor. I've created a small Arduino code module called mcs12085 that reads the delta-X and delta-Y values from the sensor as it moves. Each call to mcs12085_dx() and mcs12085_dy() gives the distance the sensor has moved in the X and Y directions in dots with the range -128 to 127. Note that the sensor has a default accuracy of 1,000 dpi so it will overflow in either direction if the sensor moves more than 3.2mm in any direction. The code uses one digital pin to act as the clock and generates the relevant clock signal, and another pin to read and write from the sensor. Before I dismantled it I used a Salae Logic analyzer to observe what the PS/2 interface chip was doing to communicate with the sensor. Here's a screen shot of the complete cycle. The top shows the clock signal and the bottom the data. It clocks in 8 bits of data corresponding to 0x02 (this is the read DX register command), pauses and reads out 8 bits (in this example the read bits were all 0). Then it clocks in 0x03 (the read DY register command), pauses and reads out 8 bits. More details of the commands possible are in this document. At some point I'll add some of them to the project.