Premium ★ 3D PRINTER DESIGNS ★ to print in 2024. Best 3D print STL files to download from a trusted 3D model website.

Update - v2 (8.13.2019)As I tried this enclosure with different DHT11 shields, I found that the lid didn't fit some shields. I also had issues wi

Колоски пшеницы 🌾🌾🌾🌾🌾🌾🌾 Вопросы в директ #колоски #мастика #тесто #каравайнасвадьбу #каравай

This is a pair of simple cases for the "Wemos ESP-8266 Board with 0.96" OLED and Battery"Both cases have a top and bottom, plus a small

This is yet another sensor box using the following components:WeMos D1 MiniTEMT6000 Light SensorAM312 PIR Motion SensorBME280 Temperature, Humidity, B

This case was made to operate the Wemos as a WLAN AP.Dieses Case wurde gemacht um den Wemos als WLAN AP zu betreiben.

A Simple 3D printed case for a WEMOS D1 Mini WiFi microprocessor board.The design of this board is slightly different from the ones with the beveled c

This is a set of Case Options for the WeMos D1 Mini line of ESP8266 development boards. It consists of 2 half shells that can be clipped together usin

Multi Cyclone Chamber captures fines dust in the air without any filter. Perfect for jobsites. Measurements Big version biggest piece (289.45mm) (28.9cm) or (11.4173 inches) Small version (207.45mm) (20.7cm) or (8.149606 inches) Units on the pictures shown as millimeter. for more info https://jolly3d.com Happy Printing

Cradle based on real furniture

Another box for ESP8266 sensor

A Delta 3D Printer: It's a new 3D printer designed by me. In order to upgrade to CNC machine,keep with constant stiffness,i use ballscrews.

Wemos D1 OLED ComboSBS (Side-By-Side), OLED combined with Wemos D1 Mini.Hot-glue Wemos D1 aside of the OLED 128x64 SSD1306. Wire it as you like (SCK a

A small project box to house a Wemos D1 Mini and Soil Moisture sensor. I've added an extra hole for the cable of a DS18B20 temperature probe too

Upload a make if you print it, i'd love to see a picturePlug together minecraft sheepThe holes dont need support.The face and eyes might need to

Explore 3D printing ideas for Easter on 3DPEA. Download the 3d printable models in STL and make them with 3D printer.

Made these parts to fit the DJI system to Floss 3 6" frame.NOTE!You need to have 6" arms to fit the separate cam cage and have enough cleara

Für die T Nut werden nach bedarf M4 Vierkantmuttern benötigt.Ich empfehle die Schlitten etwas zu schmirgeln und zu fetten.Die Löcher di

Update 02/14/2019 Added reversed filament duct so that it can be used facing up or down with the triangular design in the same orientation(two screws

Ссылка доступна только для зарегистрированных пользователей