hey loves :) Today I have a tutorial to make your own bracelets with nothing but buttons and string. Miss last week's button tutorial? Click Here :) You will need: - buttons (25ish) - embroidery floss - scissors - tape (optional) Step 1: First you need your string. When it comes to measurement, here's what I always go by: Three times the length around around your wrist, multiplied by two. You WILL have string to trim at the end, but it's worth it to make sure you're able to tie off the end. Fold it in half and then tie a knot at the fold (like the picture above) Step 2: Lay out your buttons, this will give you a projection of what your bracelet will look like when it's on the string. Step 3: For the first button, thread through the front. Cross the strings over behind (if it's a 4 hole button) and thread back through to the front. Step 4: For the second button, thread from behind. Step 5: Repeat the pattern, front thread, back thread, front thread, back thread, and so on. It'll create a nice layered effect. Continue until you you ALL BUT ONE of your buttons. Step 6: When you have only one button left, tie a knot at the end of the string. Then tie another about half an inch away. Thread the last button however you want, and then tie another knot. This is the button that will be attaching the bracelet together with the loop at the top. Cut the remaining string and you're done :) Mix it up with different buttons and different colors. See you next time loves!