Hello again... I'm back with some more bathroom updates! As I looked around in my bathroom, deciding all of its updates, I quickly decided that this nickel faucet had to go! It was a great look while it lasted. Sadly it was only about 5 years ago that it was the newest fad, and I just had to have it. But we all know me, am I gonna just go out and spend more money on this bathroom redo? I think not! I did a little research, asked a few peeps on their take on spray painting the fixtures, and decided to give it a go! Here is what I did... I bought this amazing spray paint by Rust-oleum I love these new trigger spray paints. It makes it really hard to mess up. And it doesn't get all over your hands like the other stuff. Ok well it did on mine a little because I held my hand too close to the faucet while holding it up to get in certain spots. Otherwise it doesn't get on your hands. I just laid my faucet and all its parts on a old poster board and began spraying! I'm thinking I should have sanded it down a little. But as always I was in a rush to do it, as we were going to the drive in movies after I sprayed its first coat. I also wish I would have put this in like styrofoam, then I could have done both sides at the same time. Duh, but any how I just love how it turned out! I also sprayed my toilet paper holder, my towel rack, and shower curtain rod. Oh and my light switch and plug covers. I'll reveal all that in the final reveal. I have more re-do posts, so stay tuned. Until next time... If you haven't been keeping up with the bathroom re-do process, make sure to track the process.