Yeah, I know... Christmas is over. I had fully intended on getting this post out the door BEFORE Christmas arrived. Heck, I even intended to get it posted a good week or so BEFORE the big day b/c well, that would make sense now, wouldn't it? Well, let's just chalk that up as a fail. Looking on the bright side, they are cute, fun, and better late than never. Right? RIGHT! PIN IT and put it on the crafting board for next Christmas! ;) Things you MIGHT need (depending on what you decide to do) - let me stress MIGHT. You do not need all these things to make an ornament. 1. (pearl shimmer metallic cardstock) // 2. (buttons) // 3. (hot glue gun) // 4. (plastic shot glasses) 5. (baker's twine) // 6. (Elmer's glue) // 7. (2" hole punch) // 8. (silver spray paint) 9. (mini pink or white bottle brush trees) // 10. (silver pipe cleaners) // 11. (chunky glitter) 12. (mini frosted dollhouse trees) // 13. (craft paint) // 14. (white polymer clay) 15. (penguin trinkets) // 16. (black sharpie) And here is a little diagram on how you put them together. Attaching the base to the shot glass is the tricky part. Make sure to seal your ornament shut with mod modge. 1. Punch out two circles with your 2" hole punch. One out of the white metallic cardstock and one out of some other type of card stock - a cereal box, an old greeting card, etc. Mod podge them together to make a thick circle that will be the platform of your globe. The white metallic cardstock should be what is facing up in the globe so it blends in with the glitter. 2. Glue your trinket in the center of your circle onto the white metallic side. You can put all kinds of different things in your snow globe as long as they fit. I used little dollhouse trees, silver spray painted plastic penguins and a house and snowman that I made out of white polymer clay. I got my trees from Hobby Lobby - four for $1.99. They were too tall, so I clipped them with a wire cutter and then reattached them to the base with hot glue to make them shorter. 3. Fill your shot glass with glitter - just enough to cover the base when flipped over. make sure to use chunky glitter. It looks more like snow and the super fine stuff will cling to the sides of your shot glass. 4. Take your Elmer's glue and make a thin line of glue all around the edge of your cardstock circle on the white metallic side. Please it on top of your shot glass and place something like a glass on top to weigh it down and hold it together. Let it sit for a few hours until the glue is dry. 5. Seal the ornament by putting a coat of mod podge around where the shot glass meets the cardstock. Let it dry for an hour or so. It dries much faster than the Elmer's glue. 6. Using hot glue, glue a pipe cleaner around the base of your ornament. It will cover up any imperfections of gluing the shot glass to the base. 7. String your baker's twine through your buttons and tie a know. Attach it to the top of the ornament with hot glue.