Frankenstein Light switch | Halloween | Home decor | Gift | Wall Decor | Steampunk | Mad Scientist | Scary This light switch will fit a standard U.S. light switch and is made out of PLA PLASTIC. (SCREWS NOT INCLUDED) Instructions: 1. Remove screw from wall switch plate. 2. Replace switch plate with new decorative light switch plate. 3. Place the switch rocker over the switch toggle. SIZES (approximate) --------------- Height: 4.75 inches Width: 0.89 inches Length: 3.00 inches PLA PLASTIC can warp from exposure to heat, protect from prolonged exposure to the sun and moisture. Keep in mind these are 3D printed in a small production environment. Due to the nature of this process, small imperfections can sometimes appear and are considered normal. We inspect every piece and make sure that only top quality models will go out. Design by LoboCNC https://www.printables.com/model/132335-frankenstein-light-switch-plate